Configuring Ds1/T1 Ct3 Mode Of Sts-1; Configuring Sts-Nc - Contiguous Concatenation; Configuring Aps For Satop - Cisco ASR 900 Series Configuration Manual
1 port oc48/ 4 port oc12/oc3 + 12 port t1/e1 + 4 port t3/e3 cem interface module
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (172 pages)
Table of Contents
Advertisement
Managing and Monitoring SONET Line
There is no default mode. The following modes are supported:
Note
• mode vt-15
• mode ct3
• mode t3
• mode unframed
To restore the system to its default condition, use the no form of the command.
Note
Configuring DS1/T1 CT3 mode of STS-1
To configure DS1/T1 CT3 mode of STS-1, you can configure the T1 link using the following steps:
enable
configure terminal
controller sonet 0/0/16
sts-1 1
mode ct3
t1 1 clock source internal
t1 1 framing unframed
end
To restore the system to its default condition, use the no form of the command.
Note
Configuring STS-Nc - Contiguous Concatenation
To configure STS-Nc - contiguous concatenation, use the following commands:
enable
configure terminal
controller sonet 0/0/16
sts-1 1-3 mode sts-3c
end
To restore the system to its default condition, use the no form of the command.
Note
To configure STS-3c or STS-12c, use the numbers as multiples for 3 or 12, respectively.
Note
Configuring APS for SAToP
This section describes the configuration of APS for SAToP.
1 port OC48/ 4 port OC12/OC3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
78
Configuring SONET
Advertisement
Table of Contents
Troubleshooting
