Alarm Reporting - Cisco ASR 900 Series Configuration Manual
1 port oc48/ 4 port oc12/oc3 + 12 port t1/e1 + 4 port t3/e3 cem interface module
Hide thumbs
Also See for ASR 900 Series:
- Release notes (310 pages) ,
- Manual (174 pages) ,
- Configuration manual (172 pages)
Table of Contents
Advertisement
Alarm Reporting
shutdown
end
Use the no shutdown command to disable the interface.
Note
Alarm Reporting
Enables reporting for all or selected alarms.
• b1-tca — Enables BER threshold crossing alarm for B1.
• b2-tca — Enables BER threshold crossing alarm for B2.
• b3-tca — Enables BER threshold crossing alarm for B3.
• lais —Enables line alarm indication signal.
• lom — Enables loss of multiframe signal.
• lrdi — Enables line remote defect indication signal.
• pais — Enables path alarm indication signal.
• plop — Enables loss of pointer failure signal for a path.
• pplm — Enables path payload mismatch indication.
• prdi — Enables path remote defect indication signal.
• puneq — Enables path unequipped (path label equivalent to zero) signal.
• sd-ber — Enables LBIP BER in excess of SD threshold.
• sf-ber — Enables LBIP BER in excess of SF threshold.
• slof — Enables section loss of frame signal.
• slos — Enables section loss of signal.
Configuring Alarm Reporting
To configure alarm reporting:
enable
configure terminal
controller sdh 0/0/16
alarm-report [b1-tca | b2-tca | b3-tca | lais | lom | lrdi | pais | plop | pplm | prdi |
puneq | sd-ber | sf-ber | lof | los]
end
Note
To restore the system to its default condition, use the no form of the alarm report command.
1 port OC48/ 4 port OC12/OC3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
116
Configuring SDH
Advertisement
Table of Contents
Troubleshooting
