Table of Contents
Advertisement
Additional information
12
Symptom
After using the Auto MCACC
Setup, the speaker size setting is
incorrect.
Can't adjust the Fine Speaker
Distance setting (page 37)
properly.
The display shows KEY LOCK
ON when you try to make
settings.
Most recent settings have been
erased.
Professional Calibration EQ graphical output
Symptom
The EQ response displayed in the
graphical output following
calibration does not appear
entirely flat.
EQ adjustments made using the
Manual MCACC setup on
page 36 do not appear to change
the graphical output.
Lower frequency response
curves do not seem to have been
calibrated for SMALL speakers.
Graphical output data seems to
have disappeared.
Display
Symptom
The display is dark or off.
After making an adjustment the
display goes off.
You can't get DIGITAL to display
when using the SIGNAL SELECT
button.
The Dolby/DTS indicator doesn't
light when playing Dolby/DTS
software.
When playing a DVD-Audio disc,
the DVD player display shows
96 kHz. However, the receiver's
display does not.
During playback of a DTS 96/24
source, the display doesn't show
96kHz.
76
En
Remedy
• There may have been some low frequency noise in the room from an air-conditioner, motor, etc. Switch
off all other appliances in the room and use Auto MCACC Setup again.
• Depending on a number of factors (room size, speaker placement, etc.) this may occur in some cases.
Change the speaker setting manually in Speaker Setting on page 42, and use the ALL (Keep SPsetting)
option for the Auto Mode in Automatic MCACC (Expert) on page 33 if this is a recurring problem.
• Check that the speakers are all in phase (make sure the positive (+) and negative (–) terminals are
matched up properly).
• With the receiver in standby, press
CONTROL button to disable the key lock.
• The power cord was disconnected from the wall while adjusting this setting.
Remedy
• There are cases where the graph does not appear flat (even when selecting ALL CH ADJUST in the Auto
MCACC Setup) due to adjustments made to compensate for room characteristics to achieve optimal sound.
• Areas of the graph may appear identical (before and after) when there is little or no adjustment needed.
• The graph may appear to have shifted vertically when comparing before and after measurements.
• Despite level adjustments being made, the filters used for analysis may not display these adjustments in
the graphical output. However, these adjustments are taken this into account by the filters dedicated to
overall system calibration.
• Low frequencies used in bass management (the subwoofer channel) will not change for speakers that
have been specified as SMALL in the configuration, or do not output these frequencies.
• Calibration is performed, but due to your speakers' low frequency limitations, no measurable sound is
output for display.
• If the power is switched off, the measurement data for graphical output to a PC is cleared.
Remedy
• Press DIMMER on the remote control repeatedly to select a different brightness.
• Press DIMMER on the remote control repeatedly to select a different brightness.
• Check the digital connections and make sure that the digital inputs are assigned correctly (see The Input
Setup menu on page 60).
• If the multichannel analog inputs are selected, select a different input source.
• These indicators do dot light if playback is paused.
• Check the playback (especially the digital output) settings of the source component.
• This is not a malfunction. 96 kHz audio from DVD-Audio discs is only output from the analog outputs of
the DVD player. This receiver cannot show the playback sample rate when using the analog inputs.
• Make sure that the receiver is set to AUTO or DIGITAL (see Choosing the input signal on page 28).
STANDBY/ON while holding down the MULTI-ROOM&SOURCE
- Quick Links:
- Connecting Using Hdmi
- Specifications
Hide quick links:
Advertisement
Table of Contents
