Table of Contents
Advertisement
Using other functions
Reducing the level of an analog signal
The input attenuator lowers the input level of an analog
signal when it's too strong. You can use this if you find
the that the OVER indicator is lights often, or you can
hear distortion in the sound.
SLEEP
SR+
D.ACCESS
•
Press ANALOG ATT to switch the input attenuator
on or off.
Watching video and audio sources
independently
You can listen to a sound source and select a different
video source on your TV.
SLEEP
SR+
D.ACCESS
•
While listening to a source, press VIDEO SEL ( VIDEO
SELECT ) to select the video source you want to watch.
Press repeatedly to cycle through the possible video
sources. You can select DVD, TV, SAT, DVR1, DVR2,
VIDEO1, VIDEO2 or OFF (no video signal).
Using the sleep timer
The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
SLEEP
SR+
D.ACCESS
•
Press SLEEP repeatedly to set the sleep time.
30 min
Off
• You can check the remaining sleep time at any time
by pressing SLEEP once. Pressing repeatedly will
cycle through the sleep options again.
Note
1. The attenuator isn't available with digital sources, or when using the Stream Direct modes.
2. Note that this feature will not work with video sources assigned to either of the HDMI video inputs.
3. You can also switch off the sleep timer simply by switching off the receiver.
4. If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
1
VIDEO
ANALOG
SEL
ATT
DIMMER
CLASS
VIDEO
ANALOG
SEL
ATT
DIMMER
CLASS
2
VIDEO
ANALOG
SEL
ATT
DIMMER
CLASS
60 min
90 min
3
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
SLEEP
SR+
D.ACCESS
•
Press DIMMER repeatedly to change the brightness
of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6Ω impedance rating. Use
the front panel controls to do this.
•
With the receiver in standby, press
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6Ω.
• SP 8 OHM – Use this setting if your speakers are
rated at 8Ω or more.
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
AUDIO SUBTITLE
DISP
STATUS
SIGNAL SEL
THX
MULTI OPE
SHIFT
PHASE
1
Press STATUS to check the system settings.
These appear on both the OSD and the front panel
4
display.
STATUS
96kHz
STEREO
Signal Select
SBch Processin : OFF
Video Select
MCACC Position : M1
Room2/REC SEL : SOURCE
Room3
VIDEO
ANALOG
SEL
ATT
DIMMER
CLASS
STANDBY/
HDD
DVD
CH
CH
SBch
STEREO
STANDARD
ADV. SURR
MCACC
S.DIRECT
: AUTO
: OFF
: SOURCE
10
65
En
- Quick Links:
- Connecting Using Hdmi
- Specifications
Hide quick links:
Advertisement
Table of Contents
