Table of Contents
Advertisement
Controlling the rest of your system
11
5
Use
to select a command in the sequence then
press ENTER .
If this is the first command in the sequence, select 1ST
CODE. Otherwise, simply choose the next command in
the sequence. PRES KEY flashes after you press ENTER.
6
If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7
Select the button for the command you want to
input.
The following remote control commands can be
selected:
INPUT
RECEIVER
SELECT
CD
TV
DVD
SAT
DVR2
CD-R
DVR1
i Pod
SLEEP
SR+
D.ACCESS
+10
AV PARAMETER
TOP MENU ì
TUNE
ST
SETUP
SETUP
TUNE
PTY SEARCH
GUIDE
TV CONTROL
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components, you don't need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it's the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8
Repeat steps 5–7 to program a sequence of up to
five commands.
9
When you're finished, use
from the menu and press ENTER .
You will return to the remote control SETUP menu. Select
* EXIT * again to exit.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
70
En
SYSTEM OFF
SOURCE
VIDEO 2
VIDEO 1
TV CONT
MULTI IN
ROOM2/3
TUNER
RECEIVER
VIDEO
ANALOG
SEL
ATT
DIMMER
TV CONTROL
INPUT
TV VOL
TV CH
SELECT
CLASS
DISC
ENTER
REC
CH LEVEL
A
MENU
MPX
EON
REC STOP
B
C
D
ST
T.EDIT
ENTER
RETURN
RETURN
AUDIO SUBTITLE
HDD
DISP
CH
BAND
STATUS SIGNAL SEL
SBch
STEREO
to select EDITEXIT
Using multi operations
You can start multi operations with the receiver switched
on, or in standby.
1
Press MULTI OPE.
MULTI OP flashes in the display.
2
Press an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.
Using System off
VOL
MUTE
1
Press MULTI OPE.
MULTI OP flashes in the display.
E
DVD
2
Press
CH
The command sequence you programmed will run, then
all Pioneer components will switch off
receiver.
STATUS
SIGNAL SEL
SBch
STEREO
MULTI OPE
THX
STANDARD
ADV. SURR
SHIFT
PHASE
MCACC
S.DIRECT
RECEIVER
SYSTEM OFF
INPUT
STATUS
SIGNAL SEL
RECEIVER
SOURCE
SELECT
MULTI OPE
SHIFT
CD
TV
VIDEO 2
DVD
SAT
VIDEO 1
TV CONT
SOURCE .
SBch
STEREO
THX
STANDARD
ADV. SURR
PHASE
MCACC
S.DIRECT
RECEIVER
1
, followed by this
- Quick Links:
- Connecting Using Hdmi
- Specifications
Hide quick links:
Advertisement
Table of Contents
