Cisco TelePresence SX20 Codec
Contents
Introduction
xConfiguration Network [1..1] VLAN Voice VlanId
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requires user role: ADMIN
Value space: <1..4094>
Range: Select a value between 1 and 4094.
Example: xConfiguration Network 1 VLAN Voice VlanId: 1
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API
xConfiguration
xConfiguration
NetworkServices configuration
xConfiguration NetworkServices CDP Mode
xConfiguration NetworkServices H323 Mode
xConfiguration NetworkServices HTTP Mode
51
xCommand
Enable or disable the CDP (Cisco Discovery Protocol) daemon. Enabling CDP will make the endpoint
report certain statistics and device identifiers to a CDP-enabled switch. If CDP is disabled, the
Network VLAN Voice Mode: Auto setting will not work.
Requires user role: ADMIN
Value space: <Off/On>
Off: The CDP daemon is disabled.
On: The CDP daemon is enabled.
Example: xConfiguration NetworkServices CDP Mode: On
Determine whether the system should be able to place and receive H.323 calls or not.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the possibility to place and receive H.323 calls.
On: Enable the possibility to place and receive H.323 calls (default).
Example: xConfiguration NetworkServices H323 Mode: On
Set the HTTP mode to enable/disable access to the system through a web browser. The web
interface is used for system management, call management such as call transfer, diagnostics and
software uploads.
Requires user role: ADMIN
Value space: <Off/On>
Off: The HTTP protocol is disabled.
On: The HTTP protocol is enabled.
Example: xConfiguration NetworkServices HTTP Mode: On
API Reference Guide
xStatus
Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.