Cisco TelePresence SX20 Codec Reference Manual page 118
Application programming interface (api)
Hide thumbs
Also See for TelePresence SX20 Codec:
- Reference manual (206 pages) ,
- Administrator's manual (177 pages) ,
- User manual (88 pages)
Table of Contents
Advertisement
Cisco TelePresence SX20 Codec
Contents
Introduction
Security commands
xCommand Security FIPSMode Activate
Activate FIPS (140-2) mode. NOTE: Activating FIPS mode implies a reset to factory defaults.
While in FIPS mode, software upgrade is disabled and the following limitations apply: All calls are
encrypted, unencrypted communication protocols like Telnet and HTTP cannot be used. IEEE802.1x
and SNMP are disabled. The SIP Profile Type setting cannot be Microsoft. The remote support user
is not available.
To exit FIPS mode, perform a factory reset.
Confirm: <Yes>
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand Security FIPSMode Activate Confirm: "Yes"
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API
xConfiguration
xCommand Security Persistency
118
xCommand
xCommand
Set the following features to persistent or non-persistent mode. In non-persistent mode the
information gathered by the specified feature does not persist a reboot of the system. Persistent
mode is the default. This command reboots the system.
Configuration: In non-persistent mode, all configurations are set back to default when the system
reboots.
CallHistory: In non-persistent mode call history is deleted when the system reboots.
InternalLogging: In non-persistent mode eventlog is deleted when the system reboots.
LocalPhonebook: In non-persistent mode local phone book is deleted when the system reboots.
DHCP: In non-persistent mode all IP related information is deleted when the system reboots.
ConfirmandReboot: Reboots the system.
Requires user role: ADMIN
Parameters:
Configurations(r): <NonPersistent/Persistent>
CallHistory(r): <NonPersistent/Persistent>
InternalLogging(r): <NonPersistent/Persistent>
LocalPhonebook(r): <NonPersistent/Persistent>
DHCP(r): <NonPersistent/Persistent>
ConfirmAndReboot(r): <Yes>
Example:
xCommand Security Persistency Configurations: Persistent CallHistory:
Persistent InternalLogging: Persistent LocalPhonebook: Persistent DHCP:
Persistent ConfirmAndReboot: Yes
API Reference Guide
xStatus
Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
- Quick Links:
- Table of Contents
- Commands
- Configurations
Hide quick links:
Advertisement
Chapters
Table of Contents
