Ctc Operations; Displaying Ml-Series Ethernet Statistics On Ctc - Cisco ONS 15454 Software Feature And Configuration Manual
Sonet / sdh ml-series multilayer ethernet card
Hide thumbs
Also See for ONS 15454:
- Procedure manual (850 pages) ,
- Reference manual (728 pages) ,
- Troubleshooting manual (558 pages)
Table of Contents
Advertisement
CTC Operations
This chapter covers Cisco Transport Controller (CTC) operations of the ML-Series card. All operations
described in the chapter take place at the card-level view of CTC. CTC shows provisioning information
and statistics for both the Ethernet and paket over SONET/SDH (POS) ports of the ML-Series card. For
the ML-Series cards, CTC manages SONET/SDH alarms and provisions STS/STM circuits in the same
manner as other ONS 15454 SONET/SDH traffic cards.
For information on using CTC to load a Cisco Internet Operating System (IOS) configuration file or to
open a Cisco IOS command line interface (CLI) session, see
File Through CTC, page 3-9
This chapter contains the following major sections:
•
•
•
•
•
•
Displaying ML-Series Ethernet Statistics on CTC
The Ethernet statistics window
ML-Series Ethernet ports are zero based. Display the CTC card view for the ML-Series card and click
the Performance > Ether Ports tabs to display the window.
in the window.
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
or
Managing SONET/SDH Alarms, page 2-8
SONET/SDH Circuit Provisioning, page 2-9
Table 2-2 on page 2-2
Opening a Cisco IOS Session Using CTC, page
(Figure 2-1 on page
2-2) lists Ethernet port-level statistics. The
lists the ONS 15454 Ethernet parameters.
C H A P T E R
Loading a Cisco IOS Startup Configuration
3-2.
Table 2-1 on page 2-2
describes the buttons
2
2-1
Advertisement
Table of Contents
