Additional Configurations; Setting The Mtu Size - Cisco ONS 15454 Software Feature And Configuration Manual
Sonet / sdh ml-series multilayer ethernet card
Hide thumbs
Also See for ONS 15454:
- Procedure manual (850 pages) ,
- Reference manual (728 pages) ,
- Troubleshooting manual (558 pages)
Table of Contents
Advertisement
Configuring the ML-Series POS Interfaces
Buffer
Remote hostname :
Remote interface:
Remote IP addr
B3 BER thresholds:
SFBER = 1e-5,
Carrier delay is 200 msec
Additional Configurations
To configure additional properties to match those of the interface at the far end, perform the following
steps, beginning in global configuration mode:
Command
Step 1
Router(config-if)# no keepalive
Step 2
Router(config-if)# crc {16 | 32}
Setting the MTU Size
To set the maximum transmission unit (MTU), perform the following steps, beginning in global
configuration mode:
Command
Step 1
Router(config)# interface pos
number
Step 2
Router(config-if)# mtu bytes
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
4-14
: Unstable
:
SDBER = 1e-7
1107 total input packets,
0 input short packets,
0
input long packets , 0
1
input CRCerror packets , 0
0 input abort packets
945 input packets dropped by ucode
0
total output packets, 0
0 output post-HDLC bytes
11267259 post-HDLC bytes
11267427 pre-HDLC bytes
input runt packets
input drop packets
output pre-HDLC bytes
Purpose
Turns off keep alive messages. Keep alive messages, though
not required, are recommended.
Sets the CRC value. If the device to which the POS module is
connected does not support the default CRC value of 32, set
both devices to use a value of 16.
Purpose
Enters interface configuration mode and specifies the POS
interface to configure.
Configures the MTU size up to a maximum of 9000 bytes. See
Table 4-3 on page
4-15.
Chapter 4
Configuring Interfaces
78-15224-02
Advertisement
Table of Contents
