Interoperability With Ieee 802.1D Stp; Configuring Stp And Rstp Features - Cisco ONS 15454 Software Feature And Configuration Manual
Sonet / sdh ml-series multilayer ethernet card
Hide thumbs
Also See for ONS 15454:
- Procedure manual (850 pages) ,
- Reference manual (728 pages) ,
- Troubleshooting manual (558 pages)
Table of Contents
Advertisement
Chapter 6
Configuring STP and RSTP
•
Interoperability with IEEE 802.1D STP
A switch running RSTP supports a built-in protocol migration mechanism that enables it to interoperate
with legacy IEEE 802.1D switches. If this switch receives a legacy IEEE 802.1D configuration BPDU
(a BPDU with the protocol version set to 0), it sends only IEEE 802.1D BPDUs on that port.
However, the switch does not automatically revert to the RSTP mode if it no longer receives
IEEE 802.1D BPDUs because it cannot determine whether the legacy switch has been removed from the
link unless the legacy switch is the designated switch. Also, a switch might continue to assign a boundary
role to a port when the switch to which this switch is connected has joined the region.
Configuring STP and RSTP Features
These sections describe how to configure spanning-tree features:
•
•
•
•
•
•
•
•
•
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
January 2004
Protocol migration-For backward compatibility with IEEE 802.1D switches, RSTP selectively
sends IEEE 802.1D configuration BPDUs and TCN BPDUs on a per-port basis.
When a port is initialized, the timer is started (which specifies the minimum time during which
RSTP BPDUs are sent), and RSTP BPDUs are sent. While this timer is active, the switch processes
all BPDUs received on that port and ignores the protocol type.
If the switch receives an IEEE 802.1D BPDU after the port's migration-delay timer has expired, it
assumes that it is connected to an IEEE 802.1D switch and starts using only IEEE 802.1D BPDUs.
However, if the RSTP switch is using IEEE 802.1D BPDUs on a port and receives an RSTP BPDU
after the timer has expired, it restarts the timer and starts using RSTP BPDUs on that port.
Default STP and RSTP Configuration, page 6-16
Disabling STP and RSTP, page 6-16
Configuring the Root Switch, page 6-17
Configuring the Port Priority, page 6-17
Configuring the Path Cost, page 6-18
Configuring the Hello Time, page 6-19
Interoperability with IEEE 802.1D STP
6-15
Advertisement
Table of Contents
