Table of Contents
Advertisement
Chapter 7
NPE-G1 and NPE-G2 Installation and Configuration Information
•
•
Instructions for upgrading ROMmon are in the
on page
The minimum software release for the Broadband L2TP Access Concentrator (LAC), L2TP Network
Server (LNS), and PPP Terminated Aggregation (PTA) is Cisco IOS Release 12.3(14)YM.
Also see the
configuration information.
Before enabling the second processor, you must have IP routing turned on.
Note
Processor 1 is enabled by default after you install the enabling software. To have all packets forwarded
by processor 0, use the no ip mpf command. To enable processor 1, use the ip mpf command.
Save the running configuration to NVRAM. See the
section on page
configuration mode and the setup facility, your configuration will be lost the next time you reload the
router.
Error Messages
The following error messages are displayed if a feature is configured that is not supported in the MPF
path:
Router# %MPF-4-IGNOREDFEATURES: Interface Gi0/3: Input "PBR" configurations are not MPF
supported and are IGNORED. %SYS-5-CONFIG_I: Configured from console by console
Router# (config-if)# %MPF-4-IGNOREDFEATURES: Interface Gi0/3: Input "PBR" configurations
are not MPF supported and are IGNORED.
%MPF-4-IGNOREDFEATURES: Interface Gi0/3: Output "NetFlow" configurations
are not MPF supported and are IGNORED.
Using show Commands Associated with the mpf Command
There are a variety of show commands associated with the mpf command. They are listed below along
with sample output. Use these commands to verify the mpf installation.
•
•
•
•
•
•
•
•
OL-4448-12
Upgrade the ROMmon. (The minimum ROMmon version is 12.3-4r.T3.)
Install the enabling software.
7-64.
MPF for Broadband LAC, LNS, and PTA
7-52. If you do not save the configuration settings that you created in the router using
Using the show interface stats Command, page 7-48
Using the show ip interface Command, page 7-48
Using the show mpf cpu Command, page 7-49
Using the show mpf cpu history Command, page 7-49
Using the show mpf interface Command, page 7-50
Using the show mpf ip exact-route Command, page 7-51
Using the show mpf punt Command, page 7-51
Using the show version Command, page 7-51
Network Processing Engine and Network Services Engine Installation and Configuration
Enabling the Second Processor on the NPE-G1
"Using the upgrade rom-monitor file Command" section
document for minimum memory requirements and
"Copying the Saved Configuration to NVRAM"
7-47
- Quick Links:
- Chapter 6 Npe-G2 Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
