Table of Contents
Advertisement
Removing and Replacing the NPE or NSE
When inserting SIMMs, use firm but not excessive pressure. If you damage a socket, you must return the
Caution
network processing engine or network services engine to the factory for repair.
Step 6
Gently push the SIMM into the socket until the spring latches snap over the ends of the SIMM. If
necessary, rock the SIMM gently back and forth to seat it properly.
Repeat Step 2 through Step 6 for the remaining SIMMs.
Step 7
Step 8
When all SIMMs are installed, check all alignment holes (two on each SIMM) and ensure that the spring
latch is visible. If it is not, the SIMM is not seated properly. If any SIMM appears misaligned, carefully
remove it and reseat it in the socket. Push the SIMM firmly back into the socket until the spring latches
snap into place.
This completes the SIMM replacement procedure. Proceed to the
on page
Removing SDRAM DIMMs
The procedures in this section are required only if you have an NPE-175, NPE-225, NPE-300, or NSE-1
and need to upgrade or replace the SDRAM DIMMs. On the NPE-175, NPE-225, and NSE-1, the
SDRAM DIMMs are located in socket U15. The two user-configurable SDRAM DIMMs on the
NPE-300 are located in sockets U45 and U44.
The NPE-300 contains two banks of SDRAM. Both SDRAM banks are used for all packet memory
Note
requirements; however, bank 0 is used exclusively for packet memory and is set at a fixed configuration
in the factory.
Bank 1 contains two user-configurable SDRAM slots, DIMM slot 2 and DIMM slot 3 (see
"NPE-300 and NPE-400 Overview,"
be populated by DIMMs of different sizes; however, the size of the DIMM in slot 2 must be greater than
or equal to the size of the DIMM in slot 3, and the size of the DIMM in slot 3 can be zero.
Use only SDRAM DIMMs supplied by Cisco.
Note
Use the following procedure to remove the existing DIMMs:
Turn off the system power and remove the network processing engine or network services engine from
Step 1
the system. (Follow the steps in the
Place the network processing engine or network services engine on an antistatic mat or pad and ensure
Step 2
that you are wearing an antistatic device, such as a wrist strap.
Locate the DIMM and position the network processing engine or network services engine so that you are
Step 3
facing the DIMM you want to remove.
Step 4
Open the DIMM socket latches on the DIMM to release the DIMM from the socket. (See
The DIMM is under tension in the socket; therefore, the DIMM might be released from the socket with
some force.
Network Processing Engine and Network Services Engine Installation and Configuration
9-14
9-21.
Chapter 9
the
"Components" section on page
"Removing the NPE or NSE" section on page
Removing and Installing the NPE or NSE
"Installing the NPE or NSE" section
Chapter 3,
3-2). Both slots in bank 1 can
9-9.)
Figure
9-9.)
OL-4448-12
- Quick Links:
- Chapter 6 Npe-G2 Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
