Table of Contents
Advertisement
Chapter 6
NPE-G2 Overview
Table 6-8
Table 6-8
Specification
Dimensions (H x W x D)
Connectors
The NPE-G2 supports single Gigabit Ethernet interfaces based on SFP technology. The following SFP
modules are supported by the NPE-G2:
•
100BASE-FX SFP—The SFP-GE-F=, 100BASE-FX SFP module is a hot-swappable device that
plugs into a Gigabit Ethernet SFP port. It provides full-duplex 100-Mbps connectivity between
switches over multimode fiber (MMF) infrastructures. The 100BASE-FX SFP operates on ordinary
MMF optical link spans of up to 6562 ft (2 km) in length. Customers implementing Cisco
100BASE-FX SFP can use 1000BASE-X SFP modules in the future (including SX, LH/LX, ZX, and
coarse wavelength-division multiplexing SFP modules).
1000BASE-LX/LH SFP—The SFP-GE-L=, 1000BASE-LX/LH SFP module operates on ordinary
•
single-mode fiber-optic link spans of up to 32,808 ft (10,000 m) in length.
1000BASE-SX SFP—The SFP-GE-S=, 1000BASE-SX SFP module operates on ordinary
•
multimode fiber-optic link spans of up to 1804 ft (550 m) in length.
1000BASE-ZX SFP—The SFP-GE-Z=, 1000BASE-ZX SFP module operates on ordinary single
•
mode fiber-optic link spans of up to 43.5 miles (70 km) in length. Link spans of up to 62.1 miles
(100 km) are possible using premium single-mode fiber or dispersion-shifted single-mode fiber. The
SFP module provides an optical link budget of 23 dB—the precise link span length depends on
multiple factors such as fiber quality, number of splices, and connectors.
When shorter distances of single-mode fiber are used, it may be necessary to insert an inline optical
attenuator in the link to avoid overloading the receiver. A 5-decibel (dB) or 10-dB inline optical
attenuator should be inserted between the fiber-optic cable plant and the receiving port on the
SFP-GE-Z= at each end of the link whenever the fiber-optic cable span is less than 15.5 miles (25
km).
Optical fiber cables are commercially available; they are not available from Cisco.
Note
Note
We strongly recommend cleaning optical fiber connections before attaching cables to equipment. See the
"Fiber Optic Cleaning Information" section on page 6-23
OL-4448-12
provides SFP module specifications.
SFP Module Specifications
Network Processing Engine and Network Services Engine Installation and Configuration
NPE-G2 Memory Information and Specifications
Description
Height: 0.33 in. (8.5 mm)
Depth: 0.53 in. (13.4 mm)
Width: 2.22 in. (56.5 mm)
Multimode fiber-optic: LC
Single-mode fiber-optic: LC
for information.
6-17
- Quick Links:
- Chapter 6 Npe-G2 Overview
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
