Drum Unit; Photosensitive Drum; Primary Charger; Transfer Roller - Brother mfc8440 Service Manual
Hide thumbs
Also See for mfc8440:
- User manual (426 pages) ,
- Software user's manual (183 pages) ,
- Quick setup manual (52 pages)
Table of Contents
Advertisement
CHAPTER 3 THEORY OF OPERATION
2.5
Drum Unit
2.5.1
Photosensitive drum
Generates the latent electrostatic image and develops the image on the drum surface.
2.5.2
Primary charger
Forms a uniform charge on the drum surface.
(1) Corona wire
Generates the ion charge on the drum.
(2) Grid
Spreads the ion charge evenly over the drum surface.
2.5.3
Transfer roller
Transfers the toner image to the paper from the drum surface.
2.5.4
Cleaner
Removes the paper dust or dirt on the surface of the photosensitive drum.
2.6
Toner Cartridge
Develops the electrostatic latent image on the photosensitive drum with toner and forms the
visible image.
2.7
Print Process
2.7.1
Charging
The drum is charged to approximately 870V by an ion charge which is generated by the
primary charger. The charge is generated by ionization of the corona wire, which has a DC
bias from the high-voltage power supply applied to it. The flow of the ion charge is controlled
by the grid to ensure it is distributed evenly on the drum surface. The aluminum drum sleeve
in the photosensitive drum is grounded.
Voltage
regulator
The primary charge uses a corona wire, but since the drum is positively charged, only less than
1/10 of the usual quantity of ozone is generated compared with the negatively charged drum.
The level of ozone expelled from the printer is therefore not harmful to the human body.
Applicable safety standards have been complied with.
-
-
+
-
+
- -
+
- -
+
- - - -
+ +
+ + +
+
870V
+
+
+
+
+
+
+
+
+ + +
Corona wire
Fig. 3-35
Aluminum drum sleeve
Organic photoconductor layer
Grid
HVPS
3-22
Photosensitive
drum
Advertisement
Chapters
Table of Contents
Troubleshooting
