Brother mfc8440 Service Manual page 301
Hide thumbs
Also See for mfc8440:
- User manual (426 pages) ,
- Software user's manual (183 pages) ,
- Quick setup manual (52 pages)
Table of Contents
Advertisement
APPENDIX 2 INSTALLING THE UPDATE DATA
1.3
Installing the Update Data onto the Flash ROM of the Machine
< On a PC running Windows 95 >
(1)
(2)
(3)
(4)
< On a PC running Windows 98/Me/2000 >
(1) Install the printer driver for the parallel port to your PC. (Once installed, no more
(2) Copy the update data onto the desired directory of the hard disk.
(3) Copy the transfer utility "Filedg32.exe" onto the desired directory of the hard disk.
(4) Run "Filedg32.exe".
(5) Drag and drop the update data onto the icon of the model being used in the Filedrgs
Copy the update data and transfer utility onto the desired same directory of the hard
disk. e.g., C:\UPDATE
Click the Start button, point to Programs, and then click MS-DOS Prompt to open an
MS-DOS window.
Type the drive letter where the update data and transfer utility are located. In the
above example, type C:\ from the command line and press the Enter key.
Then type CD UPDATE and press the Enter key.
To start the transfer utility transmitting the update data to the flash ROM of the
machine, type the following:
ICEN filename /b
Where filename is an update data file, e.g., 8840xxxx.dat.
Then press the Enter key.
During downloading, the machine beeps intermittently.
Upon completion of the downloading, the machine beeps continuously.
NOTE:
If the machine cannot return to the standby state after completion of downloading,
turn the power off and on.
printer driver is required for your PC.)
e.g., C:\UPDATE
The Filedrgs window will appear as shown below. (e.g., DCP-8040)
windows.
During downloading, the machine beeps intermittently.
Upon completion of the downloading, the machine beeps continuously.
NOTE:
If the machine cannot return to the standby state after completion of downloading,
turn the power off and on.
A-4
Advertisement
Chapters
Table of Contents
Troubleshooting
