Brother mfc8440 Service Manual page 254
Hide thumbs
Also See for mfc8440:
- User manual (426 pages) ,
- Software user's manual (183 pages) ,
- Quick setup manual (52 pages)
Table of Contents
Advertisement
I-16
Black spots
User Check
(1) If the problem is not solved after printing a few pages, the drum unit may have
glue from label stock on the photosensitive drum surface. Refer to Step 1 in the
table below and
(2) The drum unit may be damaged. Install a new drum unit.
Possible cause
Step
Drum unit
1
Drum
2
connection
failure
Fixing unit
3
High-voltage
4
power supply
PCB failure
NOTE
in the previous page.
Check
Are the spots at 94mm
intervals?
(The problem is not solved
after printing a few pages.)
Is the contact between the
drum unit and machine
connected correctly?
Are the spots at 79mm
intervals?
(The problem is not solved
after printing a few pages.)
Is the problem solved after
replacing the high-voltage
power supply PCB?
6-47
MFC-8440/8840D/8840DN, DCP-8040/8045D/8045DN
Result
Remedy
Yes
1) If toner or glue
remains stuck, wipe it
off gently with a
cotton swab. (Refer
to
NOTE
in the
previous page.)
2) If the photosensitive
drum is scratched or
deteriorated
(exposed), replace
the drum unit.
No
Clean contact electrode
both on the drum unit
and in the machine.
Yes
1) Check and clean the
heat roller with a cloth
dampened with
alcohol.
2) Replace the fixing
unit.
Yes
Replace the high-voltage
power supply PCB.
SERVICE MANUAL
Ground
contacts
(8)
Advertisement
Chapters
Table of Contents
Troubleshooting
