Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES
Satin stitching using the
sewing speed controller
A decorative stitch can be sewn by changing the
stitch width of a satin stitch. If the sewing machine is
set so that the stitch width can be adjusted using the
sewing speed controller, the stitch width can quickly
and easily be adjusted. In this case, the sewing speed
is adjusted with the foot controller.
a
Connect the foot controller.
• For details, refer to "Starting to sew" (page
46).
b
Attach zigzag foot "J".
• For details, refer to "Replacing the presser
foot" (page 38).
c
While holding down stitch selection key
turn on the sewing machine.
The following screen appears.
d
Press a stitch length key to select "ON".
:
* To turn off stitch width control, press a stitch
length key again to select "OFF".
e
Turn off the sewing machine, and then turn it
on again.
Stitch width control is turned on.
Sliding the sewing speed controller to the right
increases the stitch width; sliding it to the left
decreases the width.
*
appears in the LCD to indicate that
stitch width control has been turned on.
88
J
,
f
Select stitch
.
• For details, refer to "Selecting Stitching"
(page 62).
g
While sewing, slide the sewing speed
controller to adjust the stitch width.
Slide the controller to the left to make the width
narrower. Slide the controller to the right to
make the width wider.
Narrower
• Adjust the sewing speed with the foot
controller.
Memo
When the foot controller is plugged in,
("Start/Stop" button) cannot be used to
start sewing.
Although the stitching result differs
depending on the type of fabric being sewn
and the thickness of the thread being used,
for best results, adjust the stitch length to
between 0.3 and 0.5 mm (1/64 and 1/32
inch).
Wider
Advertisement
Table of Contents
