Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX
Error messages
If
("Start/Stop" button) is pressed before the sewing machine is correctly set up or if an operation is
performed incorrectly, an error message appears in the LCD. Follow the instructions that appear.
Error Message
F01~F07
116
The "Start/Stop" button was pressed without connecting the foot
controller while the setting for adjusting the stitch width using the
sewing speed controller is set to [ON].
The "Start/Stop" button was pressed while the foot controller was
connected.
A stitch other than the buttonhole, bar tack or darning stitch was
selected and the "Start/Stop" button was pressed while the buttonhole
lever is lowered.
The buttonhole, bar tack or darning stitch was selected and the "Start/
Stop" button was pressed while the buttonhole lever is raised.
The "Start/Stop" button, "Reverse/Reinforcement Stitch" button or
"Thread Cutter" button was pressed while the presser foot was raised.
The "Reverse/Reinforcement Stitch" button, "Needle Position" button
or "Thread Cutter" button was pressed while the bobbin winder shaft is
moved to the right.
The motor locked up because the thread is tangled.
If error message "F01" through "F07" appears in the LCD while the
sewing machine is being used, the machine may be malfunctioning.
Contact your nearest authorized service center.
Probable Cause
Advertisement
Table of Contents
