Table of Contents
Advertisement
—— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Select stitch
c
d
Adjust the stitch width to the thickness of the
gimp thread.
e
Lower the presser foot lever and the
buttonhole lever, and then start sewing.
When sewing is finished, gently pull the gimp
f
thread to remove any slack.
g
Use a handsewing needle to pull the gimp
thread to the wrong side of the fabric, and
then tie it.
h
With a seam ripper, cut the middle part of the
gimp thread remaining at the top end of the
buttonhole.
Trim off any excess of the gimp thread.
or
.
Button sewing
Buttons can be sewn on with the sewing machine.
Buttons with 2 or with 4 holes can be attached.
a
Measure the distance between the holes in the
button to be attached.
b
Raise the presser foot lever, and then slide the
drop feed lever, located at the rear of the
machine on the base, to
seen from the rear of the machine).
a
a Drop feed lever (as seen from the rear of the
machine)
The feed dogs are lowered.
Turn on the sewing machine.
c
d
Select stitch
.
e
Attach button fitting foot "M".
• For details, refer to "Replacing the presser
foot" (page 38).
(to the left as
Buttonhole Stitching 75
3
Advertisement
Table of Contents
