Table of Contents
Advertisement
—— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
b
Secure the quilting foot with the presser foot
holder screw.
The pin on the quilting foot should be
positioned over the needle clamp screw.
a Pin on quilting foot
b Presser foot holder screw
c Needle clamp screw
c
Hold the quilting foot in place with your right
hand, and then tighten the presser foot holder
screw using the screwdriver in your left hand.
a Presser foot holder screw
CAUTION
● Be sure to securely tighten the screws
with the screwdriver, otherwise the
needle may touch the presser foot,
causing it to bend or break.
1
3
2
1
d
Slide the drop feed lever, located at the rear of
the machine on the base, to
seen from the rear of the machine).
a
a Feed dog position switch (as seen from the rear of
the machine)
The feed dogs are lowered.
e
Turn on the sewing machine, and then select a
stitch.
• For details, refer to "Selecting Stitching"
(page 62).
Use both hands to hold the fabric taut, and
f
then move the fabric to follow the pattern.
Reinforcement stitches are sewn at the
beginning and end of sewing.
1
a Pattern
After sewing is finished, slide the drop feed
g
lever to
(to the right as seen from the rear
of the machine) and turn the handwheel to
raise the feed dogs.
a
a Drop feed lever (as seen from the rear of the
machine)
• Normally, the drop feed lever is positioned at
the right.
Appliqué, Patchwork and Quilt Stitching 87
(to the left as
3
Advertisement
Table of Contents
