Table of Contents
Advertisement
▀ Verifying Your Configuration
Verifying Your Configuration
This section explains how to display and review the configurations after saving them in a .cfg file as described in the
System Administration Guide and also to retrieve errors and warnings within an active configuration for a service.
Important:
These instructions are used to verify the GRE interface configuration.
Step 1
Verify that your interfaces are configured properly by entering the following command in Exec Mode:
show ip interface
The output of this command displays the configuration of the all interfaces configured in a context.
▄ Cisco ASR 5x00 Packet Data Network Gateway Administration Guide
270
All commands listed here are under Exec mode. Not all commands are available on all platforms.
Intf Name:
foo1
Intf Type:
Broadcast
Description:
IP State:
UP (Bound to 17/2 untagged, ifIndex 285343745)
IP Address:
1.1.1.1
Bcast Address:
1.1.1.255
Resoln Type:
ARP
L3 monitor LC-port switchover: Disabled
Number of Secondary Addresses: 0
Intf Name:
foo2
Intf Type:
Tunnel (GRE)
Description:
VRF:
vrf-tun
IP State:
UP (Bound to local address 1.1.1.1 (foo1), remote
address 5.5.5.5)
IP Address:
10.1.1.1
Intf Name:
foo3
Intf Type:
Tunnel (GRE)
Description:
IP State:
DOWN (<state explaining the reason of being down>)
Subnet Mask:
255.255.255.0
MTU:
1500
ARP timeout:
60 secs
Subnet Mask:
255.255.255.0
GRE Protocol Interface
Advertisement
Table of Contents
