Table of Contents
Advertisement
Gx Interface Support
Important:
implementation of Volume Reporting over Gx. In 10.2 and later releases, this is configurable in the standard
implementation. This is not supported in 10.0 release for standard based volume reporting.
Once the usage is reported, the usage counter is reset to zero. The PCEF continues to track data usage from the zero
value after the threshold is reached and before a new threshold is provided by the PCRF. If a new usage threshold is not
provided by the PCRF in the acknowledgement of an IP-CAN Session modification where its usage was reported, then
usage monitoring does not continue in the PCEF for that IP CAN session and and the usage accumulated between the
CCR-CCA will be discarded.
For information on how to configure the Volume Reporting over Gx feature, see the
over Gx
section.
How Rel. 7 Gx Works
This section describes how dynamic policy and charging control for subscribers works with Rel. 7 Gx interface support
in GPRS/UMTS networks.
The following figure and table explain the IMSA process between a system and IMS components that is initiated by the
UE.
In this example, the Diameter Policy Control Application (DPCA) is the Gx interface to the PCRF. The interface
between IMSA with PCRF is the Gx interface, and the interface between Session Manager (SessMgr) and Online
Charging Service (OCS) is the Gy interface. Note that the IMSA service and DPCA are part of SessMgr on the system
and separated in the figure for illustration purpose only.
Important:
Server interface application.
The Usage Reporting on Revalidation Timeout feature is available by default in non-standard
In 14.0 and later releases, the DPCA and the IMSA will be acting as one module within the Policy
Cisco ASR 5x00 Packet Data Network Gateway Administration Guide ▄
Rel. 7 Gx Interface ▀
Configuring Volume Reporting
295
Advertisement
Table of Contents
