Table of Contents
Advertisement
ICAP Interface Support
end
Notes:
In release 8.1, the
is managed by SessMgrs. In release 8.1, ACS must be enabled in the Optimized mode.
In release 8.3, the
in Optimized mode.
In release 8.0 and release 9.0 and later, the
Configuring Charging Action for ICAP Server Group
Use the following example to configure the charging action to forward HTTP/WAP GET request to ICAP server for
content processing:
configure
active-charging service <acs_svc_name>
charging-action <charging_action_name> [ -noconfirm ]
content-filtering processing server-group
end
Verifying the ICAP Server Group Configuration
This section explains how to display and review the configurations after saving them in a .cfg file and also to retrieve
errors and warnings within an active configuration for a service.
Important:
These instructions are used to verify the configuration for this feature.
Step 1
Verify your ICAP Content Filtering Server Group configuration by entering the following command in Exec Mode:
show content-filtering server-group
The following is a sample output. In this example, an ICAP Content Filtering server group named
icap_cfsg1
keyword enables ACS in the Optimized mode, wherein ACS functionality
optimized-mode
keyword is obsolete. With or without this keyword ACS is always enabled
optimized-mode
All commands listed here are under Exec mode. Not all commands are available on all platforms.
was configured.
Content Filtering Group:
Context:
Origin Address:
ICAP Address(Port):
Max Outstanding:
keyword is not available.
optimized-mode
icap_cfsg1
icap1
1.2.3.4
1.2.3.4(1344)
256
Cisco ASR 5x00 Packet Data Network Gateway Administration Guide ▄
Configuring ICAP Interface Support ▀
381
Advertisement
Table of Contents
