Table of Contents
Advertisement
Gx Interface Support
Usage Reporting
Time usage at subscriber/flow level is reported to PCRF under the following conditions:
Usage Threshold Reached: PCEF records the subscriber usage and checks if the usage threshold provided by
PCRF is reached. Once the condition is met, it reports the usage information to IMSA and continues
monitoring. IMSA then triggers the CCR-U if "USAGE_REPORT" trigger is enabled by PCRF. The Usage-
Monitoring-Information AVP is sent in this CCR with the "CC-Time" in "Used-Service-Unit" set to track the
time usage of the subscriber.
Usage Monitoring Disabled: If PCRF explicitly disables the usage monitoring with Usage-Monitoring-Support
AVP set to USAGE_MONITORING_DISABLED, PCEF stops monitoring and reports the usage information
(when the monitoring was enabled) to PCRF if the usage monitoring is disabled by PCRF as a result of CCR
from PCEF which is not related to reporting usage, other external triggers, or a PCRF internal trigger.
IP CAN Session Termination: When the IP CAN session is terminated, the accumulated subscriber usage
information is reported to PCRF in the CCR-T from PCEF.
PCC Rule Removal: When the PCRF deactivates the last PCC rule associated with a usage monitoring key,
PCEF sends a CCR with the usage time for that monitoring key. If the PCEF reports the last PCC rule
associated with a usage monitoring key is inactive, the PCEF reports the accumulated usage for that monitoring
key within the same CCR command if the Charging-Rule-Report AVP was included in a CCR command;
otherwise, if the Charging-Rule-Report AVP was included in an RAA command, the PCEF sends a new CCR
command to report accumulated usage for the usage monitoring key.
PCRF Requested Usage Report: When PCRF provides the Usage-Monitoring-Information with the Usage-
Monitoring-Report set to USAGE_MONITORING_REPORT_REQUIRED, PCEF sends the time usage
information. If the monitoring key is provided by PCRF, time usage for that monitoring key is notified to
PCRF regardless of usage threshold. If the monitoring key is not provided by PCRF, time usage for all enabled
monitoring keys is notified to PCRF.
Event Based Reporting: The event based reporting can be enabled through the CLI command
send-usage-report events
configured under this CLI, time usage report is generated whenever that event happens.
Once the usage is reported, the usage counter is reset to zero. The PCEF continues to track time usage from the zero
value after the threshold is reached and before a new threshold is provided by the PCRF. If a new usage threshold is not
provided by the PCRF in the acknowledgement of an IP-CAN Session modification where its usage was reported, then
time usage monitoring does not continue in the PCEF for that IP CAN session.
For information on how to configure the Time Reporting over Gx feature, see the
section.
Configuring Time Reporting over Gx
This section describes the configuration required to enable Time Reporting over Gx.
To enable Time Reporting over Gx, use the following configuration:
configure
active-charging service <ecs_service_name>
rulebase <rulebase_name>
. When an event like sgsn change, qos change or revalidation-timeout is
Cisco ASR 5x00 Packet Data Network Gateway Administration Guide ▄
Time Reporting Over Gx ▀
event-update
Configuring Time Reporting over Gx
335
Advertisement
Table of Contents
