Table of Contents
Advertisement
PDN Gateway Configuration
DHCPv6 Service Configuration Verification
Step 1
Verify that your DHCPv6 servers configured properly by entering the following command in Exec Mode:
show dhcpv6-service all
This command produces an output similar to that displayed below where DHCPv6 service name is
service
Step 2
Verify the DHCPv6 service status by entering the following command in Exec Mode:
show dhcpv6 status service dhcpv6_service_name
dhcpv6 ip-address-pool-name <dhcpv6_ip_pool>
dhcpv6 context-name <dest_ctxt>
exit
:
Service name:
Context:
Bind Address:
Bind :
Service Status:
Server Dead Time:
Server Dead consecutive Failure:5
Server Select Algorithm:
Server Renew Time:
Server Rebind Time:
Server Preferred Life Time:
Server Valid Life Time:
Max Retransmissions:
Server Dead Tries:
Server Resurrect Time:
ipv6_nd_flag:
DHCPv6 Servers configured:
Address:
dhcpv6-service
A
2092::192:90:92:40
Done
Started
120 (secs)
First Server
400 (secs)
500 (secs)
600 (secs)
700 (secs)
3 (secs)
4 (secs)
10 (secs)
O_FLAG
2092::192:90:92:40 Priority: 1 enabled
Cisco ASR 5x00 Packet Data Network Gateway Administration Guide ▄
Configuring the System as a Standalone eGTP P-GW ▀
dhcp6-
135
Advertisement
Table of Contents
