Removing The Footstand From The Cisco Ip Phone 7960 - Cisco 7960 Administration Manual
Ip phone administration guide for cisco callmanager 3.2
Hide thumbs
Also See for 7960:
- Administrator's manual (212 pages) ,
- User manual (186 pages) ,
- Getting started (50 pages)
Table of Contents
Advertisement
Chapter 4
Adding the Cisco IP Phone 7914 Expansion Module
Note
Removing the Footstand from the Cisco IP Phone 7960
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco IP Phone Administration Guide for Cisco CallManager 3.2, Cisco IP Phones 7960/7940/7910
78-10453-04
Connecting the Power Supply, page 4-11
•
Connecting the Footstand, page 4-12
•
To ensure a successful installation of the 7914 Expansion Module, make sure you
have read the entire
"Before You Begin" section on page
To remove the footstand from the IP Phone 7960 to which you are attaching the
7914 Expansion Module, follow these steps.
Procedure
Unplug the Cisco IP Phone 7960 network and power connections.
Unplug the handset, and headset (if one is attached to the phone).
Turn the Cisco IP Phone 7960 over and lay it on a protected flat surface to prevent
it from being scratched.
On the footstand, locate the two foot pins.
Using a flat head screwdriver, carefully push away from your body on one of the
foot pins to release it. Then carefully push away from your body on the other foot
pin to release it. Push the pins as illustrated in
You may have to lift and hold the IP Phone to support it when pushing the
Note
foot pins.
Lift off the footstand and store it separately.
Installing the 7914 Expansion Module
4-2.
Figure
4-2.
4-5
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
