Cisco ASR 9000 Series Installation Manual page 79
Aggregation services router
ethernet line card
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Chapter 1
Installing Line Cards in the Cisco ASR 9000 Series Router
Table 1-12
Command
show hw-module fpd location
<rack/slot/subslot>
show version
Table 1-13
show Commands to Display Modular Port Adapter (MPA) Information
Command
show controllers type
rack/slot/subslot/port
show interfaces type
rack/slot/subslot/port
show diag rack/slot/subslot/
show version
When a modular line card (MLC) is moved to a new slot, the system recognizes the new interfaces but
Note
leaves them in the shutdown state until you configure them and change their state to up. When a new
modular line card (MLC) is inserted into a slot where a modular line card (MLC) previously resided,
provided you reinstall the modular port adapters (MPAs) and interfaces and their cables in the same
configuration as in the previous modular line card (MLC), the interfaces will come up in the same state
as though you reinserted the old modular line card (MLC).
The following sample display shows the events logged by the system as you insert a new modular line
card (MLC) in module slot 4.
RP/0/RSP0/CPU0:Dec 21 21:55:50.318 : invmgr[246]: %PLATFORM-INV-6-OIRIN : OIR: Node
0/4/CPU0 inserted
...
RP/0/RSP0/CPU0:Dec 21 21:59:12.979 : shelfmgr[371]: %PLATFORM-SHELFMGR-6-NODE_STATE_CHANGE
: 0/4/0 A9K-MPA-4X10GE state:INITIALIZED
..
LC/0/4/CPU0:Dec 19 15:07:33.019 : ifmgr[196]: %PKT_INFRA-LINEPROTO-5-UPDOWN : Line
protocol on Interface GigabitEthernet0/4/0/0, changed state to Up
Use the following procedure to verify that the modular line card (MLC) is installed correctly:
Observe the console display messages and verify that the system discovers the modular line card (MLC),
Step 1
while the system reinitializes each interface, as follows:
OL-17500-08
show Commands to Display Modular Port Adapter (MPA) Information
Type of Information Provided
FPD version information of modular port adapters (MPAs) in the
system.
Cisco IOS XR software version, names and sources of configuration
files, and boot images.
Type of Information Provided
Network link status, register contents, and
controller chip errors.
Line status and data link protocol status for a
particular modular port adapter (MPA) port.
Statistics about data traffic sent and received by
the port.
Modular port adapter (MPA) type in that slot,
number of ports, hardware revision, part number,
and EEPROM contents.
Cisco IOS XR software version and boot images. show version
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Installing and Removing Modular Port Adapters
Example
show controllers Gigabit Ethernet
0/0/1/1
show interfaces Gigabit Ethernet
0/0/1/1
show diag 0/0/1
1-65
Advertisement
Table of Contents
Troubleshooting
