2-Port 10-Gigabit Ethernet Modular Port Adapter - Cisco ASR 9000 Series Installation Manual
Aggregation services router
ethernet line card
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Chapter 1
Installing Line Cards in the Cisco ASR 9000 Series Router
Table 1-10
Table 1-10
LED Label
A/L
STATUS
2-Port 10-Gigabit Ethernet Modular Port Adapter
The 2-Port 10-Gigabit Ethernet modular port adapter provides two cages for XFP Ethernet optical
interface modules that operate at a rate of 10 Gbps. The two XFP modules can be 10-Gigabit Ethernet
multimode or single mode connections (see
Each XFP cage on the 2-Port 10-Gigabit Ethernet modular port adapter has an adjacent A/L
(Active/Link) LED visible on the front panel. The A/L (Active/Link) LED indicates the status of the
associated XFP port, as described in
Refer to
OL-17500-08
describes the 1-Port 40 Gigabit Ethernet modular port adapter LEDs.
1-Port 40 Gigabit Ethernet Modular Port Adapter LEDs
Color
State
Off
Off
Green
On
Amber
On
Off
Off
Green
On
Amber
On
Figure 1-15
below for an example of the 2-Port 10-Gigabit Ethernet modular port adapter.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Meaning
Port is not enabled.
Port is enabled and the link is up.
Port is enabled and the link is down.
Modular port adapter power is off.
Modular port adapter is ready and operational.
Modular port adapter power is on and good, and the
modular port adapter is being configured.
Table
A-6).
Table
1-8.
Preparing for Installation
1-41
Advertisement
Table of Contents
Troubleshooting
