Firmware Upgrade - Cisco ASR 9000 Getting Started Manual
Services router
Hide thumbs
Also See for ASR 9000:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Chapter
Bringing Up Cisco IOS XR Software on the Router
Active node reload "Cause: Turboboot completed successfully"
Standby node reload "Cause: self-reset to use new boot image"
show environment Command: Example
To display environmental monitor parameters for the system, use the show environment command in
EXEC or administration EXEC mode. The show environment [options] command syntax is used.
Enter the show environment ? command to display the command options.
RP/0/RSP0/CPU0:router# show environment temperatures
The following example shows temperature information for a Cisco ASR 9000 Series Router.
Mon May 31 02:44:19.989 DST
R/S/I
0/1/*
0/RSP0/*
0/4/*
0/6/*
The following example shows LED status of the nodes in a Cisco ASR 9000 Series Router.
RP/0/RSP0/CPU0:router# show environment leds
Mon May 31 02:46:17.343 DST
R/S/I
0/RSP0/*
For more information, see Cisco ASR 9000 Series RouterInterface and Hardware Component Command
Reference document.
Firmware Upgrade
The field-programmable devices (FPDs) are hardware devices implemented on router cards that support
separate software upgrades. A field-programmable gate array (FPGA) is a type of programmable
memory device that exists on most hardware components of the router. The term FPD is introduced to
OL-28417-02
Modules
Inlet
Temperature
(deg C)
host
36.1
host
30.8
host
34.4
host
37.3
Modules LED
host
Critical-Alarm
host
Major-Alarm
host
Minor-Alarm
host
ACO
host
Fail
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
Hotspot
Temperature
(deg C)
45.1
41.5
44.5
47.9
Status
Off
Off
Off
Off
Off
Firmware Upgrade
35
Hide quick links:
Advertisement
Chapters
Table of Contents
