Configuring The Router Data Interfaces; Where To Go Next - Cisco ASR 9000 Getting Started Manual
Services router
Hide thumbs
Also See for ASR 9000:
- Command reference manual (1138 pages) ,
- Routing configuration manual (702 pages) ,
- Reference manual (696 pages)
Table of Contents
Advertisement
Where to Go Next
Command or Action
Step 6
admin
Example:
RP/0/RSP0/CPU0:router# admin
Step 7
show dsc
Example:
RP/0/RSP0/CPU0:router(admin)# sh dsc
NODE
ROLE
========================
0/RSP0/CPU0 DSC
0/RSP1/CPU0 Backup DSC
RP/0/RSP0/CPU0:router(admin)#
Configuring the Router Data Interfaces
After connecting to the router, configure the data interfaces manually. These are Gigabit Ethernet,
10-Gigabit Ethernet interfaces or the SPA based interfaces available on the SIP card. Because these
interfaces are for data traffic only, not management traffic, you cannot use SSH or Telnet to an IP address
that is part of the interfaces. For more information about configuring Gigabit Ethernet and 10-Gigabit
Ethernet interfaces, see the Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware
Component Configuration Guide.
Where to Go Next
If you have logged into the router, you can perform the general router configuration.If the router is
prompting you to enter a root-system username, bring up the router.
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
126
Introduction to the Cisco ASR 9000 Series Aggregation Services Router
Purpose
Places the router in administration EXEC mode.
Displays the RSP information for the router so that you can
verify that you have connected successfully to the console
port.
OL-28417-02
Hide quick links:
Advertisement
Chapters
Table of Contents
