Cisco ASR 903 Release Notes page 231
Hide thumbs
Also See for ASR 903:
- Installation manual (200 pages) ,
- Hardware installation manual (196 pages) ,
- Manual (147 pages)
Table of Contents
Advertisement
Symptom: Receive a event hog msg when advertise 21k to 25 k routes into MBGP and export from
a PE to other PE.
Conditions: When the redistributing routes from range of 21k to 25k customer routes from ospf into
MBGP and export from a PE to other PE.
Workaround: No workaround as of now.
•
CSCud35689
Symptoms: Queue-limit configuration at parent level of a policy or in a Vlan class/ port level is
accepted. It should be rejected
Conditions: When configuring queue limit on policy at parent level or in vlan class/ port level.
Workaround: None
•
CSCud36014
Symptoms: Multiple entries are seen in configs
Conditions: while configuring licence in bootlevel
Workaround: -none-
CSCud37927
•
Symptoms: The router does not learn remote Connectivity Fault Management (CFM) Maintenance
Endpoint (MEPs).
Conditions: If we have REP or STP on core with one port as ALT or BLK state.
Workaround: None.
CSCud38038
•
Symptom: The router records incorrect delay measurements after a reload.
Conditions: Occurs under the following conditions:
–
–
–
Workaround: You can use the following workarounds:
–
–
•
CSCud38115
Symptom: OSPF connections flap and drop traffic for approximately 20 seconds
Conditions: Occurs during stateful switchover (SSO).
Workaround: There is no workaround.
CSCud38433
•
Symptom: The router is unable to establish MPLS neighborship or ping the destination loopback
interface.
Conditions: Occurs when you configure two Equal Cost Multipath (ECMP) paths on a bridge
domain interface (BDI) using static routes.
Workaround: The following workarounds exist:
–
OL-26630-08
You configure Delay Measurement Message (DMM) on a port-channel interface.
The port-channel member links are on different interface modules (IMs).
You reload the router.
Remove the ethernet cfm global command and re-apply it after the port-channel member links
recover.
Configure PTP clock synchronization.
Use Interior Gateway Protocol (IGP) instead of static IP routes.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.9S Releases
45
- Quick Links:
- Cisco Asr 903 Router Overview
Hide quick links:
Advertisement
Table of Contents
