Cisco ASR 903 Release Notes page 195
Hide thumbs
Also See for ASR 903:
- Installation manual (200 pages) ,
- Hardware installation manual (196 pages) ,
- Manual (147 pages)
Table of Contents
Advertisement
CSCug05239
•
Symptom: Traffic drops on the router.
Conditions: This issue occurs when configuring multichassis Link Aggregation Control Protocol
(MLACP) switchover with Ethernet over Multiprotocol Label Switching (EOMPLS).
Workaround: Configure port channel with EOMPLS.
CSCug10116
•
Symptom: Traffic and ping do not flow through ATM interfaces on multiple controllers.
Conditions: Series of shutdown and no shutdown commands on the controller or interface lead to
the failure.
Workaround: There is no workaround. To recover from failure, perform an IM OIR.
CSCug18185
•
Symptom: When the interfaces comes up after bootup, traffic received on the Cisco ASR 903 Router
serial interfaces are not switched to the BDI connected to Ixia.
Conditions: This issue occurs when ARP resolution of the Ixia connected interface IP address fails.
Workaround: Ping the Ixia port connected to the Cisco ASR 903 Router from another router
connected to the Cisco ASR 903 Router using Gigabit Ethernet interface.
CSCug18630
•
Symptom: When you perform an OIR on the standby and active RSPs, CMAND crashes.
Conditions: This issue is observed after performing multiple standby OIRs and bringing the standby
machine up.
Workaround: There is no workaround.
CSCug21145
•
Symptom: When system crashes, sometimes core files are generated with CRC errors.
Conditions: This issue occurs when the system crashes under stress conditions.
Workaround: There is no workaround.
CSCug27073
•
Symptom: Multicast replication is improper when 255 outgoing interfaces (OIF's) are configured.
Conditions: This issue occurs when:
–
–
–
Workaround: There is no workaround.
CSCug31414
•
Symptom: Multicast traffic drops on changing interface configuration from TEFP to VPLS over
port channel (PoCH).
Conditions: This issue occurs when converting a layer 2 interface to layer 3; and then configuring
IP PIM and IP address in quick succession.
Workaround: Use shutdown and no shutdown command on the interface.
More Info: The problem occurs only when the adjacency create notification is received earlier than
the convert to layer 3 notification.
OL-26630-08
Perfuming IM OIR (soft/hard)
Clearing MRoutes (sometimes)
Enabling/disabling IGMP Snooping
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.9S Releases
9
- Quick Links:
- Cisco Asr 903 Router Overview
Hide quick links:
Advertisement
Table of Contents
