Cisco ASR 903 Release Notes page 196
Hide thumbs
Also See for ASR 903:
- Installation manual (200 pages) ,
- Hardware installation manual (196 pages) ,
- Manual (147 pages)
Table of Contents
Advertisement
Caveats in Cisco IOS XE 3.9S Releases
CSCug44762
•
Symptom: The POS interface stays down after using the shutdown and no shutdown commands.
Conditions: This is issue is observed when you use the shutdown and no shutdown commands on
the POS interface.
Workaround: Use the shutdown and no shutdown commands on the controller.
CSCug61357
•
Symptom: ISIS adjacency and BFD stay down after using the shutdown and no shutdown
commands.
Conditions: This issue is observed in R-LFA configurations.
Workaround: Use the shutdown and no shutdown commands again.
CSCug63862
•
Symptom: When configured, SATOP interfaces does not come up.
Conditions: This issue occurs on configuring SATOP on the router.
Workaround: Use IM OIR.
CSCug74071
•
Symptom: When scaling up MPLS-TE tunnels to full scale (512), sometimes the following message
is displayed: "%FMFP-3-OBJ_DWNLD_TO_CPP_FAILED: SIP1: fman_fp_image: adj 0x9fdd,
Flags Incomplete download to CPP failed".
Conditions: This issue occurs when MPLS-TE tunnels are scaled to full scale (512) on the router
in a single instance.
Workaround: There is no workaround.
CSCug83807
•
Symptom: Multicast traffic is dropped as TCAM entries are encountered.
Conditions: This issue occurs when TCAM entries are encountered.
Workaround: There is no workaround.
CSCug83842
•
Symptom: ATM/IMA path level controllers go down with alarms LP-AIS and T15 LOMF in the
Cisco ASR 903 Router.
Conditions: This issue occurs on either on bootup of the router or OIR of the IM. Along with these
alarms, B1/B2 alarms are reported at the controller level. As B1/B2 alarms are high priority alarms,
the path level controllers stays down.
Workaround: Reload IM or use the shutdown and no shutdown command on the main controllers.
CSCug84544
•
Symptom: POS interface output displays wrong counter values.
Conditions: This issue occurs when using PPP encapsulation.
Workaround: There is no workaround.
CSCug86963
•
Symptom: Bidirectional Forwarding Detection (BFD) is unable to resolve neighbor Address
Resolution Protocol (ARP).
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
10
OL-26630-08
- Quick Links:
- Cisco Asr 903 Router Overview
Hide quick links:
Advertisement
Table of Contents
