Cisco ASR 903 Release Notes page 171
Hide thumbs
Also See for ASR 903:
- Installation manual (200 pages) ,
- Hardware installation manual (196 pages) ,
- Manual (147 pages)
Table of Contents
Advertisement
Chapter
–
–
Workaround: Reload the router or issue a stateful switchover (SSO).
CSCud19563
•
Symptom: The T1/E1 interface module on the standby RSP crashes repeatedly.
Conditions: Occurs when the standby RSP is booting and there is a clock configured on the T1/E1
controller.
Workaround: Remove the clock configuration prior to booting the standby RSP and restore the
configuration afterwards.
CSCud22601
•
Symptom: MPLS-TP tunnels remain down after the standby RSP boots.
Conditions: Occurs when you boot the standby RSP after applying an MPLS-TP configuration and
performing an SSO. The issue occurs rarely.
Workaround: Issue a shutdown/no shutdown on the MPLS-TP tunnel. A nonintrusive workaround
is to cause a flap on the protect label switched path (LSP) by reconfiguring the path or physically
shutting down and restoring the interface.
•
CSCud23698
Symptom: The router stops applying classification and marking for a class.
Conditions: Occurs when you remove a priority level while using dual priority for the
class-map.
Workaround: Remove and reattach the policy-map on the interface.
CSCud24704
•
Symptom: The router crashes.
Conditions: Occurs when you perform an interface module OIR (reset) on the gigabit Ethernet
interface module while the standby RSP is booting.
Workaround: Perform the IM OIR after the standby RSP boots.
CSCud25813
•
Symptom: The router drops IP Multicast traffic.
Conditions: Occurs under the following conditions:
–
–
–
–
–
Workaround: Reload the router or issue a stateful switchover (SSO).
•
CSCud26154
Symptom: The router displays incorrect ENV readings.
Conditions: Occurs when you switch off one power supply unit in a dual power supply
configuration.
OL-26630-08
Remove the interface from the port channel
Add the EFPs back onto the interface
You initiate multicast traffic to a single L3M group.
You configure 50 EFPs with corresponding bridge domain interfaces (BDIs) and initiate
IGMPv2 join traffic to a single multicast group.
You add 25 EFPs with 25 bridge-domain interfaces (BDIs) at a 1:1 ratio.
You remove 10 EFPs from the group of 50 and add the same EFPs to the group of 25.
The newly added EFPs do not receive any traffic.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.8S Releases
29
- Quick Links:
- Cisco Asr 903 Router Overview
Hide quick links:
Advertisement
Table of Contents
