Cisco ASR 903 Release Notes page 146
Hide thumbs
Also See for ASR 903:
- Installation manual (200 pages) ,
- Hardware installation manual (196 pages) ,
- Manual (147 pages)
Table of Contents
Advertisement
Limitations and Restrictions
Multicast is not supported on POS, MLPPP and OC-12 interfaces.
•
MPLS is supported only on PoS and MLPPP interfaces; MPLS on T1/E1 links is not supported.
•
IP-FRR and BFD-triggered FRR are not supported on MPLS over POS links.
•
Fragmentation is not supported with Multicast traffic on PoS interfaces.
•
QoS is not supported with Multicast traffic on PoS interfaces.
•
QoS is supported on POS interfaces on optical interface module.
•
Three-level QoS policies are not supported on OC-3/OC-12 serial, MLPPP, and PoS interfaces. You
•
can only apply QoS policies on two levels on these interfaces.
Pseudowire/AToM Limitation
The Cisco ASR 903 Router supports ATM over MPLS N-to-one cell mode for a single ATM Virtual
•
Channel Connections (VCCs) or Permanent Virtual Circuits (PVCs) to a pseudowire, but does not
support mapping to multiple VCCs or PVCs.
The Cisco ASR 903 Router does not support ATM over MPLS one-to-one cell mode.
•
The Cisco ASR 903 Router supports pseudowire ping using the CW method; pseudowire ping using
•
the TTL method is not supported.
The Cisco ASR 903 Router supports a maximum of 2000 pseudowires in any combination.
•
The following pseudowire (PW) features are supported over MPLS-TP connections:
ATM over MPLS PWs
•
ATM attachment circuits
•
AAL5 Encapsulation
•
ATM VC Class Support
•
Cell Relay including VC mode, VP mode, and Packed Cell Relay
•
CESoPSN
•
•
L2VPN pseudowire redundancy
•
Multi-segment PWs
•
PW OAM/Status TLV Support
•
PW Redundancy
SAToP
•
The following pseudowire (PW) features are not supported over MPLS-TP connections:
ATM OAM Cell Emulation for ATM AAL5 over MPLS on PVC and in VC Class.
•
BFD / VCCV over ATM AC over MPLS TP
•
BFD/ VCCV over TDM PW over MPLS TP Manageability
•
Ethernet VLAN to Ethernet VLAN L2VPN interworking (bridged and routed modes)
•
Ethernet VLAN to ATM AAL5 L2VPN Interworking (bridged and routed modes)
•
Ethernet port to ATM AAL5 PVC L2VPN Interworking (bridged and routed modes)
•
Layer 2 QoS features such as classifying or marking based on an L2 value
•
•
MIB support including PW-TDM-MIB, PW-ATM-MIB, and PW-CESOPSN-MIB
•
N:1 PVC Mapping with non-unique VPI (N>1)
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
4
Chapter
OL-26630-08
- Quick Links:
- Cisco Asr 903 Router Overview
Hide quick links:
Advertisement
Table of Contents
