Table of Contents
Advertisement
5. Separator Installation
The separator of the Printer contributes to smooth paper feeding. Set the separator
by inserting its edge into the two holes located at the rear part of the frame of the
printer mechanism. (See Fig. 11)
Paper
6. Paper Loading
6.1. Loading of fanfold paper
The MX-82 Printer accommodates fanfold paper from 4" to 10" in width. To load
the fanfold paper, observe the following procedure.
STEP 1. Raise the printer lid.
2. Turn the scale toward the front of the Printer and detach it from the platen.
3. Confirm that the paper guide roller is at the center of the sprocket shaft. If
not, set it at the center of the shaft.
NOTE: The paper guide roller contributes to smooth paper feeding.
4. Raise the two paper holding covers, and be sure to insert the fanfold paper
between the frame and plastic roller of the separator. (See Fig. 12)
Fig. 11 Separator installation
- 1 0 -
Advertisement
Table of Contents
