Table of Contents
Advertisement
(2) When the Printer falls into paper-out status, it is automatically put in the OFF-line
state and paper advancement can be performed by depressing the LF switch.
After setting new paper in the Printer, depress the ON-LINE switch so that the
Printer may resume operation.
(3) There is another way to start the Printer again when it falls into paperout status.
Set new paper in the Printer, and turn the POWER switch off and on again, or ap-
ply the INIT signal. In this case, however, all previously established data such as
TAB, line spacing, etc. are cancelled.
(4) The paper end detecting function is useful to prevent erroneous printing when
the Printer is out of paper, If printing of characters up to the last line is to be con-
tinued, the paper end detecting function may be made invalid by either of the fol-
lowing two methods.
(a) Set the DIP switch pin 1-6 to the ON position, and the paper end detecting
function will become invalid hardwarewise.
(b) Enter control code "ESC 8" and the paper end detecting function will become
invalid softwarewise.
4. Self-Test
The MX-82, MX-82 F/T has a self-test (self-diagnostic) function to check the follow-
ing.
(1) Print head operation and printing quality.
(2) Operation of the printer mechanisms (motor, cartridge ribbon mechanism, belt,
etc.)
The self-test function is pre-programmed and can be performed by turning the
POWER switch on while depressing the LF switch. All characters provided by the in-
ternal software are printed out on the paper by this operation.
NOTES: 1. The self-test function cannot be performed when the printer is out of
paper.
2. To check all interface logic including the interface connector, proceed
as follows:
a) Connect ACKNLG signal pin No. 10 to STROBE signal pin No. 1 with
a lead wire.
Advertisement
Table of Contents
