Table of Contents
Advertisement
3. Installation of the Printer
(1) Operating site selection
When installing the MX-82 F/T, observe the following instructions.
(a) Place the Printer on a bench, tabletop or any other convenient flat surface
with enough room for the separator in the back of the Printer. Your layout
may look like Fig. 20.
NOTE: Rubber feet are provided to prevent the marring of the surface where
the MX-82 F/T is placed.
(b) Avoid operating the MX-82 F/T in places where it may be exposed to direct
sunlight or where a great deal of greasy dust exists in the air.
NOTE: Greasy dust may cause the malfunction of the print head.
(c) Connect the power cord to an outlet separated from those connecterd to
electric noise-generating equipment, such as large-power motors, refrigera-
tors, etc.
(d) Do not subject the Printer to temperatures below 5'C (40°F) or above 35°C
(95°F) during operation, to sudden changes in temperature, or to extreme
shock.
(e) Avoid using the Printer in humid locations or in the vicinity of heat generating
sources such as heater, etc.
CRT Display
Fig. 20 Laying Printer on Firm Surface
- 1 9 -
MX-82 F/T Type II
Advertisement
Table of Contents
