Cisco 7206VXR - VPN Bundle Router Configuration Manual page 21
Configuration guide
Hide thumbs
Also See for 7206VXR - VPN Bundle Router:
- Installation manual (150 pages) ,
- Supplementary manual (42 pages)
Table of Contents
Advertisement
Chapter 1
Cisco 7200 VXR Product Overview
See
Table 1-1
Physical Specifications
Description
Midplane
Dimensions
(H x W x D)
Weight
Heat dissipation
Chassis fan noise
levels—single speed
fan
Airflow
Temperature
Humidity
Power Specifications
AC-input voltage rating 100–240 VAC
AC-input current rating 5A
AC-input frequency
rating
AC-input cable
DC-output power
DC-input voltage rating –48 VDC
OL-5013-09
Table 1-1
for the Cisco 7200 VXR physical specifications and power requirements:
Specification
Two primary PCI buses, and one secondary PCI bus
With an NPE-G2 or NPE-G1 and an I/O controller installed, the I/O controller does not use
•
bandwidth points, and the NPE-G2 or NPE-G1 does use bandwidth points. The NPE-G2 or
NPE-G1 does not use bandwidth points if installed without the I/O controller.
With an NSE-1, NPE-400, or NPE-300 installed: aggregate bandwidth of 900 Mbps
•
With n NPE-100, NPE-150, or NPE-200 installed: aggregate bandwidth of 600 Mbps
•
Three primary PCI buses—With the NPE-G2 or NPE-G1 installed, no I/O controller, and the Port
Adapter Jacket Card installed, three PCI buses are available. Aggregate bandwidth of the PCI buses
is 900 Mbps. The third PCI bus goes to the Port Adapter Jacket Card and provides unlimited
bandwidth for one port adapter.
5.25 in. x 16.8 in. x 17 in. (13.34 cm x 42.67 cm x 43.18 cm)
Chassis fully configured with a network processing engine or network services engine, I/O
controller, maximum number of port adapters, 2 power supplies, and a fan tray: ~ 50 lb (22.7 kg)
2
370W (1262 BTU
)
Tested:
Front (I/O controller and port adapter side) 44.2 dB
•
Back (power supply side) 43.7 dB
•
Left (fan side) 47.2 dB
•
Right 44.8 dB
•
Maximum: 65 dB
3
~80 cfm
32 to 104•F (0 to 40•C) operating; –4 to 149•F (–20 to 65•C) nonoperating
F (0 to 40•C) operating; –4 to 149•F (–20 to 65•C) nonoperating
10 to 90% noncondensing
4
wide input with power factor correction
5
at 100–240 VAC with the chassis fully configured
6
50/60 Hz
7
18 AWG
three-wire cable, with a three-lead IEC-320 receptacle on the power supply end, and a
country-dependent plug on the power source end
280W maximum (with either a single or dual power supply configuration)
8
nominal in North America
–60 VDC nominal in the European Community
Cisco 7200 VXR Installation and Configuration Guide
Physical Description
1
1-3
Advertisement
Table of Contents
Troubleshooting
