Port Adapter Jacket Card Leds; Port Adapter Leds; System Bootup Banner; Troubleshooting The Power Subsystem - Cisco 7206VXR - VPN Bundle Router Configuration Manual
Configuration guide
Hide thumbs
Also See for 7206VXR - VPN Bundle Router:
- Installation manual (150 pages) ,
- Supplementary manual (42 pages)
Table of Contents
Advertisement
Troubleshooting the Power Subsystem
•
•
•
Port Adapter Jacket Card LEDs
The Port Adapter Jacket Card has two LEDs. The Port Adapter Jacket Card functions only with an
NPE-G1 installed. These LEDs function when the Port Adapter Jacket Card is installed in the I/O
controller slot with a port adapter installed in the Port Adapter Jacket Card:
•
•
Port Adapter LEDs
The ENABLED LED on each port adapter or service adapter comes on when the network processing
engine or network services engine completes its initialization of the adapter for operation. The
ENABLED LED indicates that the adapter is receiving power and has been recognized by the network
processing engine or network services engine; it does not indicate the state of the individual interfaces
on the adapters. If an ENABLED LED fails to come on, proceed to the
Adapters or Service Adapters" section on page
System Bootup Banner
When all LEDs come on to indicate that the system has booted successfully, the initial system banner
should be displayed on the console screen. If it is not displayed, see
VXR Router,"
the terminal is set correctly and that it is properly connected to the I/O controller's console port.
Troubleshooting the Power Subsystem
Check the following to help isolate a problem with the power subsystem:
•
Cisco 7200 VXR Installation and Configuration Guide
5-6
The USB port LEDs on the NPE-G2 are off when there is no activity.
The FE LINK LED on the NPE-G2 is solid green when there is no activity on the management port.
The CF ACTV LED on the NPE-G2 is off when there is no activity on the CompactFlash Disk.
Also see the
"NPE-G2 LEDs" section on page
The ENABLE LED comes on when the Port Adapter Jacket Card is enabled for operation.
The PWR (power) LED comes on when the Port Adapter Jacket Card is receiving power.
the
"Connecting to the Console and Auxiliary Ports" section on page 3-34
On the first power supply, is the PWR OK LED on?
If yes, the power source is good, and the power supply is functional.
–
If no, make sure the AC power supply power cable is connected at both ends.
–
If no, make sure the circuit breaker is switched to the on position for DC power supply leads.
–
If the PWR OK LED remains off, and the power switch is set correctly, suspect the power source
–
or the power cable. Turn the switch off, connect the power cable to another power source, if
available, and turn the switch back on. If the LED comes on, the problem is the first power
source.
–
If the PWR OK LED fails to come on after you connect the power supply to a new power source,
replace the power cord, and turn the switch back on. If the AC power (or input power) LED then
comes on, return the first power cable for replacement.
Chapter 5
1-41.
"Troubleshooting the Port
5-9.
Chapter 3, "Installing a Cisco 7200
Troubleshooting the Installation
to verify that
OL-5013-09
Advertisement
Table of Contents
Troubleshooting
