Cisco 7206VXR - VPN Bundle Router Configuration Manual page 106
Configuration guide
Hide thumbs
Also See for 7206VXR - VPN Bundle Router:
- Installation manual (150 pages) ,
- Supplementary manual (42 pages)
Table of Contents
Advertisement
Rack-Mounting a Cisco 7200 VXR Router
Figure 3-8
1
1
Cable-management bracket screws
If you have an NPE-G1 or NPE-G2 installed, you will want to install standard cable-management
brackets on the rear of the router as well as on the front of the router.
Step 1
If the back of the router protrudes from the rack, place the cable-management brackets against the router
as shown in
Insert two screws into each bracket, and tighten them to the router.
Step 2
Insert the GBIC cables or RJ-45 cables into the interface ports on the NPE-G1, or the SFP module cables
Step 3
or RJ-45 cables into the interface ports on the NPE-G2.
Place the cables through the cable-management brackets.
Step 4
Cisco 7200 VXR Installation and Configuration Guide
3-10
Installing the Standard Rear Cable-Management Brackets with an NPE-G1 or
NPE-G2—Router Front-Mounted
G I G A B I T E T H E R N E T 0 / 1
G I G A B I T E T H E R N E T 0 / 1
L I N K
L I N K
E N
E N
R J 4 5
R X
G B I C
T X
R J 4 5
R X
G B I C
Figure
3-8.
G I G A B I T E T H E R N E T 0 / 1
NETWORK PROCESSING ENGINE - G1
S L O T
L I N K
A C T I V E
C P U
R E S E T
E N
T X
R J 4 5
R X
G B I C
T X
POWER
C O M PA C T F L A S H
OK
CONSOLE
Chapter 3
Installing a Cisco 7200 VXR Router
1
AUX
OL-5013-09
Advertisement
Table of Contents
Troubleshooting
