Brother KE-436C Instruction Manual page 49

Electronic lockstitch pattern tacker with stepping foot and programming function

Hide thumbs Also See for KE-436C:

Table of Contents

9. STANDARD ADJUSTMENTS

9-7-1. Replacing the movable knife and fixed knife

2615Q

1. Open the large shuttle hook cover, remove the bolts (1) and the feed plate (2).

2. Remove the two screws (3) and the two screws (4), and then remove the needle plate (5).

3. Remove the thread trimmer connecting rod (6) from the connecting rod lever pin (7).

2946Q

4. Remove the movable knife (8) and replace it with a new one. At this time, check that the movable knife (8) and the fixed

knife (9) cut the thread cleanly. If necessary, adjust by using the appropriate movable knife washer (10) (supplied as

accessories).

* Apply grease to the outside of the collar (11) at this time.

5. Install the fixed knife (9) at a distance of 0.5 mm from the needle hole plate (12).

6. Place the thread trimming connecting rod (6) onto the connecting rod lever pin (7), and then install to the needle plate (5).

KE-436C

2485Q

2947Q

Table of Contents

Show Quick Links

Table of Contents