Lubrication; Lubrication Points - Brother KE-436C Instruction Manual
Electronic lockstitch pattern tacker with stepping foot and programming function
Hide thumbs
Also See for KE-436C:
- Parts manual (73 pages) ,
- Specifications (8 pages) ,
- Instruction manual (228 pages)
Table of Contents
Advertisement
4. LUBRICATION
Turn off the power switch before starting lubricating, otherwise the machine may operate if the foot switch is
depressed by mistake, which could result in injury.
Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get
into your eyes or onto your skin, otherwise inflammation can result.
Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vomiting and
diarrhoea.
Keep the oil out of the reach of children.
Note 1: Fill the machine with oil when the oil level is down to about one-third full in the oil sight glass.
If oil is not added and the oil drops below this level, there is the danger that the machine may seize during operation.
Note 2: Be sure to let the machine operate for a while after adding the oil.
Note 3: If there is no more oil on the felt of the shuttle race base, problems with sewing may result, so add oil to the felt until it
is slightly soaked.
Note 4: Use only specified Brother oil (Nisseki Mitsubishi Sewing Lube 10N;VG10) for the machine oil.
4-1. Lubrication points
1. Fill the arm-side oil tank with oil.
3. Add oil to the felt (1) of the shuttle race base.
* When setting up the sewing machine and when it
hasn't been used for an extended period of time, be
sure to add 2-3 drops oil to the felt.
CAUTION
2685Q
2. Fill the bed-side oil tank with oil
2512Q
4. If using the liquid cooling tank (2), fill it with silicon oil
2
(100 mm
/s).
KE-436C
4. LUBRICATION
2686Q
2513Q
16
Hide quick links:
Advertisement
Table of Contents
