Adjusting The Thread Take-Up Amount - Brother KE-436C Instruction Manual

Electronic lockstitch pattern tacker with stepping foot and programming function

Hide thumbs Also See for KE-436C:

Table of Contents

9. STANDARD ADJUSTMENTS

9-6. Adjusting the thread take-up amount

Thread take-up amount (stroke)

2559Q

At the time of shipment from the factory, the thread take-up amount (stroke) of the thread take-up lever (1) is set to the

standard setting of 5 mm. You may need to adjust this setting depending on the sewing conditions to prevent the thread from

pulling out at the sewing start.

Adjustment method

Loosen the screw (2) and move the stopper (3.57 nut) (3) to adjust the operating angle of the thread take-up solenoid (4).

* To reduce the thread take-up amount, move the stopper (3) downward.

* To increase the thread take-up amount, move the stopper (3) upward.

Note:

Do not increase the stroke of the thread take-up lever any more than is necessary.

If the sub-thread tension is too high, the needle thread length may become too short and the thread may come out of the

needle. Furthermore, if the sub-thread tension is too weak, the needle thread length may become too long and the

underside of the article being sewn may become untidy.

KE-436C

Become greater

Become less

2722Q

Table of Contents

Show Quick Links

Table of Contents