Brother KE-436C Instruction Manual page 60
Electronic lockstitch pattern tacker with stepping foot and programming function
Hide thumbs
Also See for KE-436C:
- Parts manual (73 pages) ,
- Specifications (8 pages) ,
- Instruction manual (228 pages)
Table of Contents
Advertisement
Memory switches (20 - 2F)
Switch No.
During feed test operation, jump feeding 100 stitches at a time is possible using the STEP
memo-20
BACK switch.
After the home position is detected and the machine moves to the sewing start position, the
memo-21
work clamp rises automatically.
memo-22
memo-23
memo-24
The enlargement and reduction ratio settings at the operation panel are fixed at the values
memo-25
when memo-25 was set to ON.
memo-26
Thread trimming is not carried out.
The sewing speed setting at the opration panel is fixed at the value when memo-27 was set
memo-27
to ON.
memo-28
Set to ON when using the thread take-up device.
memo-29
Work clamp lifting and lower thread winding before home position detection are disabled.
memo-2A
memo-2b
memo-2c
memo-2d
memo-2E
When the input voltage is being checked, the display shows the temperature of the heat sink
memo-2F
on the main circuit board instead of the voltage.
11. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES
Motion when set to ON
KE-436C
Initial value
ON
: OFF
54
Hide quick links:
Advertisement
Table of Contents
