Work Clamp Interchangeability; Adjusting The Needle Up Stop Position - Brother KE-436C Instruction Manual
Electronic lockstitch pattern tacker with stepping foot and programming function
Hide thumbs
Also See for KE-436C:
- Parts manual (73 pages) ,
- Specifications (8 pages) ,
- Instruction manual (228 pages)
Table of Contents
Advertisement
9-11. Work clamp interchangeability
9-12. Adjusting the needle up stop position
2619Q
The BAS-311E, 311F work clamp can also be used with the
KE-436C.
Replace the feed bar guide cover (1) with the feed bar guide
cover assembly, LL (2) (optional).
Then, change the installation position for the presser arm
assembly (3) from the standard installation position A to
installation position B.
To use the BAS-311E, 311F work clamp and the KE-
436C work clamp interchangeably
Use the optional work clamp 434EMK2 air (5) with the KE-
436C work clamp.
It can then be used interchangeably with the BAS-311E,
311F work clamp (6) at installation position B.
2620Q
The needle up stop position is adjusted so that the index
mark (2) on the machine pulley (1) is inside the mark (4) on
the belt cover (3).
If adjustment is necessary, loosen the screw (5) at the "U"
mark of the machine pulley (1) and adjust the position of the
machine pulley (1). The machine pulley (1) stops later if it is
turned clockwise, and it stops earlier if it is turned
counterclockwise.
Note:
The screw (6) at the "D" mark is an adjusting screw for
the needle down detection function and is adjusted to
match the feed timing, so it should not be loosened.
The screw (7) is a screw for detecting the machine stop
position, and should not be loosened.
* If the index mark (2) is not inside the mark (4) when the
sewing machine is started, error code "E.22" will be
displayed (when memory switch No.14 is on). Turn the
machine pulley to move the index mark (2) to the correct
position and then start the sewing machine.
2576Q
KE-436C
9. STANDARD ADJUSTMENTS
46
Hide quick links:
Advertisement
Table of Contents
