Maintenance And Inspection; Checking The Needle; Cleaning The Rotary Hook - Brother KE-436C Instruction Manual

Electronic lockstitch pattern tacker with stepping foot and programming function

Hide thumbs Also See for KE-436C:

Table of Contents

8. MAINTENANCE AND INSPECTION

Turn off the power switch before carrying out cleaning, otherwise the machine may operate if the foot switch is

depressed by mistake, which could result in injury.

Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get

into your eyes or onto your skin, otherwise inflammation can result.

Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vomiting and

diarrhoea. Keep the oil out of the reach of children.

Wait until the motor has cooled down before cleaning the air holes.

The motor may be hot immediately after it has been used, and it may cause burns if touched.

CAUTION

Always check that the tip of the needle is not broken and

also the needle is not bent before starting sewing.

1236S

1. Pull the shuttle race cover toward you to open it, and then

0122Q

remove the bobbin case.

2. Open the setting claw (1) in the direction indicated by the

arrow, and then remove the shuttle race body (2) and the

shuttle hook (3).

2548Q

3. Clean all the dust and thread ends from around the driver

(4), the top of the rotary hook thread guide and the shuttle

race.

2549Q

KE-436C

8. MAINTENANCE AND INSPECTION

Table of Contents

Show Quick Links

Table of Contents