Installing The Control Box - Brother KE-436C Instruction Manual

Electronic lockstitch pattern tacker with stepping foot and programming function

Hide thumbs Also See for KE-436C:

Table of Contents

3-2. Installing the control box

Check that the IM sticker is attached to the side of the control box (in the position shown in the illustration).

(KE series machine heads can only be used with control boxes which have the IM sticker attached.)

1. Remove the 12 screws (1), and then open the covers (panel mounting assembly (2) and main P.C. board mounting plate

(3)).

Note:

When opening the cover, hold it securely so that it does not fall down.

2. Install the control box with the four accessory bolts (4), spacers (5), flat washers (6) and nuts (7) as shown in the illustration

above.

* Use two nuts (7) at each installation location, and make sure that both nuts are tightened.

3. Close the covers (panel mounting assembly (2) and main P.C. board mounting plate (3)), and tighten them with the screws

(1).

* The main P.C. board mounting plate (3) will be opened again during "3-13. Connecting the cords", so provisionally

tighten it with the screw (1).

4. Install the power switch (8) with the two screws (9).

5. Secure the power switch cord with the three staples (10).

KE-436C

3. INSTALLATION

Spacers

Flat washers

Nuts

2454Q

Table of Contents

Show Quick Links

Table of Contents