Configuring Dhcp-Based Autoconfiguration; Dhcp Server Configuration Guidelines; Configuring The Tftp Server - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 3
Assigning the Switch IP Address and Default Gateway
Configuring DHCP-Based Autoconfiguration
These sections contain this configuration information:
•
•
•
•
•
•
If your DHCP server is a Cisco device, see the "Configuring DHCP" section of the "IP Addressing and
Services" section of the Cisco IOS IP Configuration Guide, Release 12.2 for additional information
about configuring DHCP.
DHCP Server Configuration Guidelines
Follow these guidelines if you are configuring a device as a DHCP server:
You should configure the DHCP server with reserved leases that are bound to each switch by the switch
hardware address.
If you want the switch to receive IP address information, you must configure the DHCP server with these
lease options:
•
•
•
•
If you want the switch to receive the configuration file from a TFTP server, you must configure the
DHCP server with these lease options:
•
•
•
Depending on the settings of the DHCP server, the switch can receive IP address information, the
configuration file, or both.
If you do not configure the DHCP server with the lease options described previously, it replies to client
requests with only those parameters that are configured. If the IP address and the subnet mask are not in
the reply, the switch is not configured. If the router IP address or the TFTP server name are not found,
the switch might send broadcast, instead of unicast, TFTP requests. Unavailability of other lease options
does not affect autoconfiguration.
OL-8915-01
DHCP Server Configuration Guidelines, page 3-5
Configuring the TFTP Server, page 3-6
Configuring the DNS, page 3-6
Configuring the Relay Device, page 3-6
Obtaining Configuration Files, page 3-7
Example Configuration, page 3-8
IP address of the client (required)
Subnet mask of the client (required)
DNS server IP address (optional)
Router IP address (default gateway address to be used by the switch) (required)
TFTP server name (required)
Boot filename (the name of the configuration file that the client needs) (recommended)
Hostname (optional)
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Assigning Switch Information
3-5
Advertisement
Table of Contents
Troubleshooting
