Configuring The Ssh Server; Displaying The Ssh Configuration And Status - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 6
Configuring Switch-Based Authentication
Configuring the SSH Server
Beginning in privileged EXEC mode, follow these steps to configure the SSH server:
Command
Step 1
configure terminal
Step 2
ip ssh version [1 | 2]
Step 3
ip ssh {timeout seconds |
authentication-retries number}
Step 4
end
Step 5
show ip ssh
or
show ssh
Step 6
copy running-config startup-config
To return to the default SSH control parameters, use the no ip ssh {timeout | authentication-retries}
global configuration command.
Displaying the SSH Configuration and Status
To display the SSH server configuration and status, use one or more of the privileged EXEC commands
in
Table
Table 6-3
Command
show ip ssh
show ssh
OL-8915-01
Purpose
Enter global configuration mode.
(Optional) Configure the switch to run SSH Version 1 or SSH Version 2.
•
1—Configure the switch to run SSH Version 1.
2—Configure the switch to run SSH Version 2.
•
If you do not enter this command or do not specify a keyword, the SSH
server selects the latest SSH version supported by the SSH client. For
example, if the SSH client supports SSHv1 and SSHv2, the SSH server
selects SSHv2.
Configure the SSH control parameters:
Specify the time-out value in seconds; the default is 120 seconds. The
•
range is 0 to 120 seconds. This parameter applies to the SSH
negotiation phase. After the connection is established, the switch uses
the default time-out values of the CLI-based sessions.
By default, up to five simultaneous, encrypted SSH connections for
multiple CLI-based sessions over the network are available (session 0
to session 4). After the execution shell starts, the CLI-based session
time-out value returns to the default of 10 minutes.
Specify the number of times that a client can re-authenticate to the
•
server. The default is 3; the range is 0 to 5.
Repeat this step when configuring both parameters.
Return to privileged EXEC mode.
Show the version and configuration information for your SSH server.
Show the status of the SSH server connections on the switch.
(Optional) Save your entries in the configuration file.
6-3:
Commands for Displaying the SSH Server Configuration and Status
Purpose
Shows the version and configuration information for the SSH server.
Shows the status of the SSH server.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring the Switch for Secure Shell
6-41
Advertisement
Table of Contents
Troubleshooting
